Re: [Paparazzi-devel] Funjet1.xml airframe software questions.

[Pascal Brisset]

Hi Stephen,

what happen when you switch to AUTO2 with throttle killed (first blocks 
of the basic.xml flight plan for example) ? Does your motor run full 
throttle ?
If not, it is the radio configuration which is reversed. Which model 
are you using ?

--Pascal

Stephen L Hulme wrote:
> *2)* I reversed the funjet1.xml command section as follows to get the 
> surfaces moving in the right direction from the RC transmitter as set 
> out here:
>  
> <!-- commands section -->
>   <servos>
>     <servo name="MOTOR"                 no="0" min="2000" 
> neutral="2000" max="1000"/>
>     <servo name="AILEVON_LEFT"   no="2" min="1880" neutral="1500" 
> max="1130"/>
>     <servo name="AILEVON_RIGHT" no="6" min="1170" neutral="1515" 
> max="1980"/>
>   </servos>
>  
> Unfortunately the throttle strip setting always reads the reverse of 
> the RC transmitter throttle stick position and the actions of the motor.
>  
> Motor off stick towards me -100% reading. and vice versa.
>  
> Can I change this?
>  
>  
> Regards
>  
> Stephen .
>
>  
>  
>  
>  
>  
>  
>  
>  
>  
>  
>  
>  
>  
>  
>  
>  
>  
> ------------------------------------------------------------------------
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>