Re: [Paparazzi-devel] No throttle in Auto2

[cory barton]

Sorry. I always try to indicate how I solved the problem, so that
people who actually search the mailing list can get answers.

The removal of the datalink sections of the airframe config was what
did the trick.

A big thank you to everyone who pitched in on this issue.

When my plane is happily flying, you are all a part of my success, and
if it crashes, then it will be my own fault. :P

Cory

On Fri, Aug 22, 2008 at 8:46 PM, Bernard Davison
<address@hidden> wrote:
> Hi Cory,
>
> I've just ordered my hardware and will have a very similar setup to yours.
> So I've been watching this thread pretty closely...
>
> What was the cause of the problem in the end?
> Was it the DATALINK lines in your config?
>
>
> Thanks,
> Bernie.
>
> On 23/08/2008, at 4:47 AM, cory barton wrote:
>
>> Pascal,
>>
>> Thanks, your advice got me going. Now I have two way comms.
>>
>> Thank you to everyone who helped out with this.
>>
>> Cory
>>
>> On Fri, Aug 22, 2008 at 10:49 AM, Pascal Brisset <address@hidden>
>> wrote:
>>>
>>> Hi,
>>>
>>> I suppose Jeremy speaks about the -uplink argument of the link agent. It
>>> is
>>> now the default (and uplink can be disabled with the -nouplink argument).
>>>
>>> So it is not your problem.
>>>
>>> If you use the transparent mode, you have to remove or comment out all
>>> the
>>> DATALINK sections (I see you have it twice in your airframe file)
>>>
>>> You can try to run the link agent in debug mode (stop the one from the
>>> Paparazzicenter and run it directly from the shell) :
>>>
>>> PPRZ_DEBUG='l' PAPARAZZI_SRC=. PAPARAZZI_HOME=.
>>> sw/ground_segment/tmtc/link
>>>
>>> You should see some "mm sending" message
>>> (sw/ground_segment/tmtc/link.ml:313)
>>>
>>> --Pascal
>>>
>>> David Buzz Carlson wrote:
>>>>
>>>> Can anybody confirm this?  And if so, what is the parameter that needs
>>>> set?
>>>>
>>>> Thanks,
>>>> David
>>>>
>>>> address@hidden wrote:
>>>>>
>>>>> As I recall, the default behavior is to not send data to the plane.
>>>>> There is some parameter that must be added in order to enable sending.
>>>>>  I
>>>>> don't know the flag or where to put it though :(  I think it goes on
>>>>> the
>>>>> link line?
>>>>>
>>>
>>>
>>>
>>> _______________________________________________
>>> Paparazzi-devel mailing list
>>> address@hidden
>>> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>>>
>>
>>
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden
>> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>