[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Paparazzi-devel] R/C controller

From: TurboTas
Subject: [Paparazzi-devel] R/C controller
Date: Wed, 16 Jul 2008 12:47:38 -0700 (PDT)

Hi there Chen,

This issue really had me stumped for a while as My Hitec Lazer 6 two 'extra' 
channels were only connected to two-position switches and were not connected to 
A/D converters in the radio.

To Uses PPRZ properly (safely!) I think you really will need a 3 position 

My fix was to disconnect the rudder channel inside my RC Tx and connect this to 
a 3 position 2 pole switch which in turn switches in resistors to make the 
three distinct values needed.  It's actually a really easy mod once you work 
out what you are doing!

Just so long as you don't need the rudder channel for your other models, that 
would probably work fine.  Shout if you need more details!  This way is also 
much more cost effective than the Big radios with 3 position switches.


Not happy with your email address?.
Get the one you really want - millions of new email addresses available now at 

reply via email to

[Prev in Thread] Current Thread [Next in Thread]