RE: RE: [Paparazzi-devel] Blank GCS frame!

[address@hidden]

Yes, u-center defaults to temporary settings, you must check the box to make it permanent and you may need to upload the settings twice if the baud rate change causes the upload to fail.  Power cycle it to be sure it holds the new settings.

The tunnel code allows u-center to see the gps, this is the only purpose of the tunnel - to bypass the autopilot and communicate directly with the gps.  When you flash with regular code, only the autopilot can communicate with the gps and it will send pprz data down the serial port that only the pprz GCS can interpret.

-- address@hidden wrote:

When you use Ucenter, you must click a box to save to flash memory.  I dont quite remember where, but I think its on the wiki. 

 

AJ

> -------- Original Message --------
> Subject: Re: RE: [Paparazzi-devel] Blank GCS frame!
> From: Mohammad Ali Haji Pour <address@hidden>
> Date: Wed, April 30, 2008 7:59 am
> To: address@hidden
>
> BTW I forgot to mention that after uploading the code into the AP, I cannot get anything from GPS in the u center with the FTDI cable.
>
> Best Regards,
>
> Mohammad
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> Paparazzi-devel@nongnu.org
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel


_____________________________________________________________
Click here for free information on consolidating your debt.