paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Tiny v2


From: Michel GORRAZ
Subject: Re: [Paparazzi-devel] Tiny v2
Date: Sat, 5 Jan 2008 14:10:46 +0100

Ooops, just swap the comment on pin #4 & #5:

TINY v2 GND ("Download" header pin #1) --> PC serial adapter ground
TINY v2 BOOT ("Download" header pin #4) --> attach to ground (instructs the controller to enter programming mode on UART0)
TINY v2 GPS_RESET ("Download" header pin #5) --> attach to ground (disable the GPS receiver to avoid serial bus conflict on UART0)
TINY v2 TXD0 ("Download" header pin #6) --> PC serial adapter RX (5V or 3.3V)
TINY v2 RXD0 ("Download" header pin #7) <-- PC serial adapter TX (5V or 3.3V)

Sorry.

@+
Michel

2008/1/5, Michel GORRAZ <address@hidden>:
Hi,

To install the USB bootloader on Tiny v2, make up a wiring harness similar to the following:

TINY v2 GND ("Download" header pin #1) --> PC serial adapter ground
TINY v2 BOOT ("Download" header pin #4) --> attach to ground (disable the GPS receiver to avoid serial bus conflict on UART0)
TINY v2 GPS_RESET ("Download" header pin #5) --> attach to ground (instructs the controller to enter programming mode on UART0)
TINY v2 TXD0 ("Download" header pin #6) --> PC serial adapter RX (5V or 3.3V)
TINY v2 RXD0 ("Download" header pin #7) <-- PC serial adapter TX (5V or 3.3V)

Once this wiring is ready, power up the board and you will be ready to send the USB Bootloader to the Tiny v2 from the PC.

Soon in the wiki :)

@+
Michel

2008/1/4, Uttam Chandrashekhar < address@hidden>:
OK guys, we scoped it, it's oscillating nicely, and the power on reset is working fine. Should I just follow the steps in the wiki for the previous version of Tiny?

-TIA
Uttam




Looking for last minute shopping deals? Find them fast with Yahoo! Search.

_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel




reply via email to

[Prev in Thread] Current Thread [Next in Thread]