paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Berg Receiver Mod


From: address@hidden
Subject: Re: [Paparazzi-devel] Berg Receiver Mod
Date: Thu, 18 Oct 2007 16:06:02 GMT

Just run the antenna out the wing and it'll be far and perpendicular from everything.  I've found that the Berg works better with a wire antenna cut to some random length than with a base loaded antenna.  Don't know why, I read somewhere that the Berg does some automatic impedence matching magic and I noticed that it comes with a random length antenna (newer versions are 1m).

-- Matthew Currie <address@hidden> wrote:
Jeremy,


  Sounds about right.  Just as a side note I am almost SURE they are using some thin conformal coating on this receiver.  It was difficult to get reflow and it gave off an odd odor.  There also appear to be drops of something in between closely spaced components, etc.. I am not absolutely sure but it made me wonder.  You are right that impedance-wise, this circuit could be less susceptible to the affects of moisture but then I had never considered moisture mucking with RF circuitry =)  I will be abandoning the coating and already had some suitable lightweight shrink set aside I had used for building small battery packs.  I also plan on using some surplus 1206 SMT ferrite chokes which I used to filter ~ 72MHz and coming up with a clever way to incorporate them in series with this wiring for a more bulletproof link.  I used to use these in other RC products I designed and they made a dramatic difference to glitching.

  On a somewhat related note.  Would it be more suitable to use a 1/4" whip or something out of solid rod and make an antenna that could get perpendicular faster instead of running past every transceiver in th plane?  Only thinking out loud here.  I have a few of those tiny tuned antennas meant for parkflyers which turn the 30+" wire into a 4" antenna at the expense of a quoted 10% range as well.


Regards,
Matthew

address@hidden wrote:

The IR sensors use very large value resistors that are easily affected by humidity but the receiver does not rely on such things.  Also 72MHz is a pretty low frequency and not so sensitive to detuning.  Lastly, Castle Creations doesn't coat these receivers and they know a lot more about it than we do. :)

Just slap some heat shrink on it, keep it away from the GPS, and try to keep the antenna perpendicular to other antennas.

-- Matthew Currie <address@hidden> wrote:
Group,


 I will be modifying the Berg 4L receiver tonight and was curious if
there is any reason why I should _not_ coat the entire assembly in an
Aerosol Silicone Conformal Coating for protection mechanically and
problems of moisture in foggier weather, etc.  While I realize the IR
sensors may be of limited use in rain / fog I sure don't want the weak
link to be something I can correct for now.  My only reasons for being
cautious would be RF detuning, contamination, etc.


Regards,
Matthew Currie


_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel


_______________________________________________ Paparazzi-devel mailing list address@hidden http://lists.nongnu.org/mailman/listinfo/paparazzi-devel

reply via email to

[Prev in Thread] Current Thread [Next in Thread]