Re: [Paparazzi-devel] debugging

[David Armstrong]

Hi Pascal ,

i am working on the Airbourne code , adding in what i need for the Gas 
Turbine Ecu & realtime Monitoring , i have 2 olimex dev boards linked as a 
classix , purely because it was easier for using the jtag than patching a 
classix Pcb

also i am more familiar to using Crossworks under windows than i am under 
Debian , but i don't mind digging deeper into Debian if thats a better route 
.
i'll no doubt have to dig more in to debian for the GCS mods  later , to add 
the shaft  rpm & temperature monitoring for the case pressure & exaust temp 
, although i may discuss this with you later when you have time , and 
formulate a plan

Regards
Dave



----- Original Message ----- 
From: "Pascal Brisset" <address@hidden>
To: <address@hidden>
Sent: Monday, July 09, 2007 9:42 PM
Subject: Re: [Paparazzi-devel] debugging


> Hi Dave,
>
> Paparazzi Pcb wrote:
> > has anyone built the airbourne code under windows ? , i am having a 
> > problem debugging the code
> What code are you talking about ? Airborne or GCS code ?
>
> --Pascal
>
> > and would like to run it using Crossworks for windows or Linux for that 
> > matter , is it feasable , or whats the best enviroment  to debug in 
> > realtime or near to under debian . or if anyone has a project file for 
> > crossworks for linux it would help .
> >  Dave
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
> ---
> avast! Antivirus: Inbound message clean.
> Virus Database (VPS): 000755-0, 09/07/2007
> Tested on: 09/07/2007 21:46:13
> avast! - copyright (c) 1988-2007 ALWIL Software.
> http://www.avast.com



---
avast! Antivirus: Outbound message clean.
Virus Database (VPS): 000755-0, 09/07/2007
Tested on: 09/07/2007 22:01:19
avast! - copyright (c) 1988-2007 ALWIL Software.
http://www.avast.com