[paparazzi-builds] [paparazzi] Failed: master build #1184

[Semaphore]

Build 1184 Failed for project paparazzi on branch master

View on Semaphore

Last commit for this build

	podhrmic	08 Oct 19:50
a97b6cd — Better start for sbus_fakerator (thanks @flixr)

Build Results

68:38

Thread #1

ls -lah $SEMAPHORE_CACHE_DIR

00:00

df -h

00:00

docker pull flixr/pprz-dev

18:23

df -h

00:00

sudo rm -rf /home/runner/{.phpbrew,.phpunit,.kerl,.kiex,.lein,.nvm,.npm,.rbenv}

00:11

df -h

00:00

git --version

00:00

git status --ignored

00:00

git submodule deinit --force .

00:00

rm -rf .git/modules

00:00

git submodule update --init --force --recursive

01:02

if [ "$SEMAPHORE_TRIGGER_SOURCE" = "scheduler" ]; then docker/run.sh -it flixr/pprz-dev make test_all_confs ; else docker/run.sh -it flixr/pprz-dev make test ; fi

48:15

( Showing only the last 30 out of 101 lines. For a complete log visit the build page )

        Warning: AIRCRAFT=LadyLisaBluegiga target=ap compiled sucessfully but had warnings:
No SRTM data found to check altitude.

Warning: Waypoint 'dummy' too far from HOME (59>20)



# compiling AIRCRAFT: [LadyLisaBluegiga] TARGET: [nps]

tests/aircrafts/01_compile_all_aircrafts.t .. 6/9 
Warning: AIRCRAFT=LadyLisaBluegiga target=nps compiled sucessfully but had warnings:
No SRTM data found to check altitude.

Warning: Waypoint 'dummy' too far from HOME (59>20)


subsystems/ahrs/ahrs_int_cmpl_quat.c:47:2: warning: #warning "Using both magnetometer and GPS course to update heading. Probably better to configure USE_MAGNETOMETER=0 if you want to use GPS course." [-Wcpp]
 #warning "Using both magnetometer and GPS course to update heading. Probably better to configure USE_MAGNETOMETER=0 if you want to use GPS course."
  ^


# compiling AIRCRAFT: [MavTecLS] TARGET: [ap]

tests/aircrafts/01_compile_all_aircrafts.t .. 7/9 # compiling AIRCRAFT: [MavTecLS] TARGET: [nps]

tests/aircrafts/01_compile_all_aircrafts.t .. 8/9 
                                                   
tests/aircrafts/01_compile_all_aircrafts.t .. ok
All tests successful.
Files=1, Tests=9, 37 wallclock secs ( 0.02 usr  0.01 sys + 76.12 cusr 19.92 csys = 96.07 CPU)
Result: PASS
failed conf/airframes/TUDELFT/tudelft_conf.xml
failed conf/airframes/FLIXR/flixr_conf.xml
Makefile:316: recipe for target 'test_all_confs' failed
make: *** [test_all_confs] Error 1

      

df -h

00:00

Manage your email notification settings.

Is this email not displaying correctly? Report the issue.

Sent by Semaphore