[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [changeset] colorbar bug
From: |
Ben Abbott |
Subject: |
Re: [changeset] colorbar bug |
Date: |
Sun, 01 Mar 2009 19:57:47 -0500 |
On Mar 1, 2009, at 1:52 PM, dbateman wrote:
Ben Abbott wrote:
This changeset addresses two bugs I encountered.
(1) Two colorbar commands produced two colorbars.
(2) colorbar ("off") did not turn off the colorbar.
Demos are included which verify the intended behavior.
This fix was trivial, and has been pushed to savannah.
Ben
I'm not sure (1) is a bug. Yes I noticed this behavior when I
reimplement
colorbar in 3.2, but kept it as that is similar behavior to matlab
when I
tested it. However, I think its probably better to only have a single
colorbar so the fix is fine.
D.
I should have checked what Matlab does.
>> clf
>> set(0,'handleVisibility','on')
>> plot(1:10)
>> hc1 = colorbar
hc1 = 173
>> hc2 = colorbar
hc2 = 173
Thus Octave's present implementation shoud not delete colorbar replace
it with a new one, but should update it.
When given a new location, a second colorbar is created.
>> hc3 = colorbar('westoutside')
hc3 = 203
I did not expect this behavior. The fix should be trivial. I'll look
at it.
Ben