RE: Environment variables with start program

[Weedy]

If you need THAT many variables you should source them from the start function of your script.

On 20 Feb 2014 17:56, "Mehul Ved" <address@hidden> wrote:

Hi Martin,

  I did try this but it did not load the environment variables. Let me try it again though, if I did anything wrong back then.

---

From: monit-general-bounces+mehul.ved=address@hidden <monit-general-bounces+mehul.ved=address@hidden> on behalf of Martin Pala <address@hidden>
Sent: Thursday, February 20, 2014 6:33 PM
To: This is the general mailing list for monit
Subject: Re: Environment variables with start program

 

Hi,

you can wrap the script in shell like this:

start program = "/bin/bash -c '/etc/init.d/myprogram start'"

The shell will load its profile (set environment variables).

Regards,

Martin

On 20 Feb 2014, at 12:38, Mehul Ved <address@hidden> wrote:

Hi,

I have a node.js services that I want to be monitored by monit. I have written a bash script to start and stop these services. The script works fine when run from my bash console. But, it fails when run through monit, as explained on FAQ page that monit uses execv and thus environment variables are not available.

One of the workarounds that people have been using is:

/usr/bin/env KEY=value myscript.sh

Unfortunately, I can't use that since I have a lot of variables, some of which are quite long and thus exceed the 127 character limit.

Is there any other way I can have my environment variable available to the start program script?

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general