Execute script if monit fails to send

[Holder, Shane]

Hello all,

 

I have a situation where I have network utilization constraints so I would like to not make unnecessary network calls if possible.  Our network also goes down frequently so I need a way to execute a recovery process if we detect that the network has gone down.  Our configuration of monit is to use M/Monit to monitor our devices so I was wondering if it was possible for monit to detect that it was unable to send and then execute the recovery process.  I know that I could put in an additional rule to connect to the mmonit server but I would like to not add the additional network check if possible.

 

Thanks,

 

Shane Holder  |  address@hidden
Solutions Architect |  AmerisourceBergen Specialty Group

3101 Gaylord Parkway, 2W-E131  |  Frisco, TX 75034

(469)365-7727

 

CONFIDENTIALITY NOTICE. This electronic mail transmission may contain privileged, confidential and/or protected health information and is intended only for the review of the party to whom it is addressed.  Any unauthorized use or disclosure of the information contained herein may be a violation of federal law, including the Health Insurance Portability and Accountability Act (HIPAA). If you have received this transmission in error, please immediately return it to the sender, delete it  and destroy it without reading it. Unintended transmission shall not constitute the waiver of the attorney-client or any other privilege.