Re: Process and parent process id is -1

[Martin Pala]

Btw. PID and PPID can be -1 if monit initializes ... the service was  
not tested yet. This can be caused by the configuration ...

Martin

On Oct 10, 2007, at 8:39 PM, Martin Pala wrote:

> Can you run monit in verbose mode (using -v option) and check logs?  
> What's your monit configuration and which service/process from the  
> configuration you try to check? Does 'monit status' show the PID?  
> Is the PID -1 all the time? What's the content of the related pidfile?
>
> Thanks,
> Martin
>
>
> On Oct 10, 2007, at 7:15 PM, Kelly Breed wrote:
>
> > Sorry to trouble the group with this, but I've searched high and  
> > low for the answer to this.  Why is it that my process status  
> > pages are showing -1 for both the pid and the parent pid?  I'm not  
> > even sure what relevant information to include here except to say  
> > that monit is working fine, so it must know the pids, but they  
> > just don't show up on the html page.
> >
> > Thank you!
> >
> > Kelly
> >
> >
> > --
> > To unsubscribe:
> > http://lists.nongnu.org/mailman/listinfo/monit-general
>
>
>
> --
> To unsubscribe:
> http://lists.nongnu.org/mailman/listinfo/monit-general