Re: informing monit of a new checksum

[Martin Pala]

In the case you forgot, you can either unmonitor&&monitor the given  
service after the upgrade or reload monit (send HUP)

Martin

On Jul 16, 2007, at 2:26 PM, Ian P. Christian wrote:

> Hi Martin,
>
> So in cases where you have upgraded and forgot to unmonitor the
> service, you will have to HUP monit to get it to accept a new
> checksum?
>
> Thanks,
>
> Ian
>
> On 7/16/07, Martin Pala <address@hidden> wrote:
> > Hi,
> >
> > you should disable monitoring before upgrade (unmonitor) and enable
> > after upgrade (monitor). If you are using static checksum in monit
> > control file, you will need to fix it and reload monit configuration
> > (either "monit reload" or send HUP to monit).
> >
> > Martin
> >
> > On Jul 16, 2007, at 2:05 PM, Ian P. Christian wrote:
> >
> > > I'm monitoring file checksums with monit of my services -  
> > however when
> > > I upgrade the service, monit clearly complains.
> > >
> > > Short of HUPng the process, how do I tell monit that it's ok? I
> > > couldn't see it in the manual, and telling monit to monitor the  
> > file
> > > again via teh web interface fails.
> > >
> > > Thanks,
> > >
> > > Ian
> > >
> > >
> > > --
> > > To unsubscribe:
> > > http://lists.nongnu.org/mailman/listinfo/monit-general
> >
> >
> >
> > --
> > To unsubscribe:
> > http://lists.nongnu.org/mailman/listinfo/monit-general
>
>
> --
> To unsubscribe:
> http://lists.nongnu.org/mailman/listinfo/monit-general