[Ltib] NM revision in tool chain

[Chris Westervelt]

Stuart,

 

I am in the process of producing an upgrade to Gstreamer and its plugins to version 0.10.28.  I also have to upgrade other support libraries as well.  The one common denominator I am running into that prevents libtool from working is the current tool chains NM.  If I patch by preempting the configure in the spec files with “lt_cv_path_NM=/usr/bin/nm \” I can get the packages to build.  My question is am I doing this the right way?  I want to submit all this work to the project but I want to insure I have a solution that everyone can benefit from.  I am building on Ubuntu 10.04.  This may not be the best location for all platforms.  Your thoughts.

 

Chris Westervelt

Senior Product Development Engineer

Infrasafe, Inc.
12612 Challenger Pkwy
Suite 300
Orlando, FL
32826

http://www.infrasafe.com
Office:   (407) 926-6983

Mobile: (407) 595-7023       
Fax:    (407) 857-1635
Notice of Confidentiality:
This e-mail communication and the attachments hereto, if any, are intended solely for the information and use of the addressee(s) identified above and may contain information which is legally privileged and/or otherwise confidential. If a recipient of this e-mail communication is not an addressee (or an authorized representative of an addressee), such recipient is hereby advised that any review, disclosure, reproduction, re-transmission or other dissemination or use of this e-mail communication (or any information contained herein) is strictly prohibited. If you are not an addressee and have received this e-mail communication in error, please advise the sender of that circumstance either by reply e-mail or by telephone at (800) 238-2686, immediately delete this e-mail communication from any computer and destroy all physical copies of same.