listhelper-moderate
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Qemu-devel post from address@hidden requires approval


From: qemu-devel-owner
Subject: Qemu-devel post from address@hidden requires approval
Date: Sun, 01 Jul 2007 20:48:46 -0400

As list administrator, your authorization is requested for the
following mailing list posting:

    List:    address@hidden
    From:    address@hidden
    Subject: Support for Intel Pro network cards
    Reason:  Post by non-member to a members-only list

At your convenience, visit:

    http://lists.nongnu.org/mailman/admindb/qemu-devel
        
to approve or deny the request.
--- Begin Message --- Subject: Support for Intel Pro network cards Date: Mon, 2 Jul 2007 12:48:11 +1200

Hi,

 

I’m trying to get Juniper software running on QEMU. I’ve managed to get it installed and operational however I can’t setup a network interface as the software is very specific about the type of network card it will accept. In vmware you can do the following to have it emulate an intel adaptor ethernet0.virtualDev = "e1000", which shows up as an em interface under freeBSD.

 

Is there any support for this with QEMU?

 

Regards Jeff

This communication, including any attachments, is confidential. If you are not the intended recipient, you should not read it - please contact me immediately, destroy it, and do not copy or use any part of this communication or disclose anything about it. Thank you. Please note that this communication does not designate an information system for the purposes of the Electronic Transactions Act 2002.


--- End Message ---
--- Begin Message --- Subject: confirm 80bccd13cb47e8af54f9b6d602d84d516becaa20
If you reply to this message, keeping the Subject: header intact,
Mailman will discard the held message.  Do this if the message is
spam.  If you reply to this message and include an Approved: header
with the list password in it, the message will be approved for posting
to the list.  The Approved: header can also appear in the first line
of the body of the reply.

--- End Message ---

reply via email to

[Prev in Thread] Current Thread [Next in Thread]