[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: how to create the same appearance of a full-measure rest in spite of
From: |
Kenneth Wolcott |
Subject: |
Re: how to create the same appearance of a full-measure rest in spite of time signature? |
Date: |
Sun, 8 Aug 2021 16:25:02 -0700 |
Thank you!
On Sun, Aug 8, 2021 at 4:06 PM Carl Sorensen <c_sorensen@byu.edu> wrote:
>
>
>
> On 8/8/21, 5:01 PM, "lilypond-user on behalf of Kenneth Wolcott"
> <lilypond-user-bounces+carl.d.sorensen=gmail.com@gnu.org on behalf of
> kennethwolcott@gmail.com> wrote:
>
> Hello again,
>
> An update to my earlier question. I'm engraving a piece now that
> uses 5/4 and 6/4 time signatures. I have a full measure rest for one
> of each time signatures. I'd like to have a single rest note for
> those measures, not "r1 r4" and not "r1 r2". How to do that?\
>
> R1*5/4 in 5/4
> R1*6/4 or R1. In 6/4
>
> HTH,
>
> Carl
>
>
> What about "9/8"? Etc...things that don't have a denominator of 4.
>
> Thanks,
> Ken
>
> On Tue, Jul 27, 2021 at 7:27 PM David Kastrup <dak@gnu.org> wrote:
> >
> > Kenneth Wolcott <kennethwolcott@gmail.com> writes:
> >
> > > Well, that was stupid of me :-(
> > >
> > > I replaced, in the current engraving, "r2." with "R2.".
> > >
> > > It works as I had desired.
> >
> > LilyPond still needs you to specify the duration, yes, even though the
> > appearance is almost always the same (there are exceptions like 3/1
> > meter where using a semibreve rest would be too confusing).
> >
> > > Sorry for the noise.
> >
> > Happens.
> >
> > --
> > David Kastrup
>
>
>