Nathan:
Thank you for your reply and the correction – not ugly at all especially since it works!
Mark
From: Nathan [mailto:address@hidden
Sent: Friday, May 10, 2013 8:55 AM
To: Mark Stephen Mrotek
Cc: LilyPond Users
Subject: Re: Cadenza alignment
On Fri, May 10, 2013 at 8:24 AM, Mark Stephen Mrotek <address@hidden> wrote:
Hello:
A small cadenza appears at the end of a piano piece (see attached file).
The “des2.” in the treble should be in the next measure.
The error message is: “barcheck failed at: 1/2 ees2\trill\fermata|.”
How do I correct this?
Thank you for your kind attention.
Mark
Attached are my corrections. Sorry if they're ugly :/
The problem was that the #(skip-of-length TheCadenza) in the left hand happened a quarter note later than the cadenza in the right hand.