Re: rests missing

[Mats Bengtsson]

It seems to be some problems with the numeric font.
If you make a .ly file containing the following two lines

\version "2.6.0"
\markup{\number 0123456789 }

and process it with LilyPond, you should get an output PDF, where
the numbers 0-9 are printed in a nice bold font. My guess is that some
of the numbers are missing when you try it. Unfortunately, I don't have
any direct clue on why it fails, though.

 /Mats

Rob wrote:

> Hi,
>
> Since a few days I use version 2.6.3. from a debian package (Kubuntu)
>
> I ran in the following two problems.
>
> 1)
>
> \override MultiMeasureRest #'expand-limit = 1
> \set Score.skipBars = ##t
> R1*4
>
> Result:
> 1 single rest-measure with the number 4 written above.
>
> When I change to
>
> R1*6 (or 7 or ...)
> There is a 6 (or7 or...) written above
>
> but:
> R1*5  gives no a 5 written above it; in fact here is nothing!
>
> 2)
>
> A more or less identical problem is shown in \time
>
> when I write
> \time 2/4 or 6/8
> in the Staff it is shown as 2/4 and 6/8
>
> In
> \time 3/4 only the "4" is shown in it's proper place,
> which is the lower part of the Staff
> but  
> in stead of a "3" above it there is a blank place
>
>
> What can I do about it?
>
> Rob
>
>
>
>
> _______________________________________________
> lilypond-user mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/lilypond-user
>  

--
=============================================
        Mats Bengtsson
        Signal Processing
        Signals, Sensors and Systems
        Royal Institute of Technology
        SE-100 44  STOCKHOLM
        Sweden
        Phone: (+46) 8 790 8463                         
       Fax:   (+46) 8 790 7260
        Email: address@hidden
        WWW: http://www.s3.kth.se/~mabe
=============================================