[libredwg] Install Linux Mint 19.3

[Joe Carmichael]

Hello,

I cannot install on Linux Mint 19.3. I installed as a user. It failed and I tried again as sudo with the same result. The guide says to email here for any help.

Steps I took, following the guide on libreplanet here.

• cd Downloads
• git clone git://git.sv.gnu.org/libredwg.git
• cd libredwg
  
• sh autogen.sh

That command throws the following output.

• ➜  libredwg git:(master) sh autogen.sh
  + rm -rf autom4te.cache config.status
  + test -d .git -a -f build-aux/git-version-gen
  + git fetch --tags
  + rm .tarball-version
  rm: cannot remove '.tarball-version': No such file or directory
  + build-aux/git-version-gen .tarball-version
  + v=0.10.1.1198_1b2c3
  + echo 0.10.1.1198_1b2c3
  + echo 0.10.1.1198_1b2c3
  + set -e
  + autoreconf --install --symlink -I m4
  autogen.sh: 24: autogen.sh: autoreconf: not found
  

I tried the next steps just in case the above was expected.

• ➜  libredwg git:(master) ./configure --enable-trace
  zsh: no such file or directory: ./configure
  ➜  libredwg git:(master) make
  make: *** No targets specified and no makefile found. Stop.

I stopped at this point. Is there any advice on what steps to take next to try and install this? Any help is appreciated!

Thank you.

Kind regards,

Joe