|
From: | Gábor Csárdi |
Subject: | Re: [igraph] [Igraph] Help |
Date: | Fri, 2 May 2014 20:15:17 -0400 |
During the installation procedure library IGRAPH using cygwin, when running the command <"make check"> at the end of several test execution finished with status <failed>. I wonder if this may cause a problem (error) future or if that act is considered normal.
If not, what should I run correction procedures?Thank you
_______________________________________________
igraph-help mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/igraph-help
[Prev in Thread] | Current Thread | [Next in Thread] |