Re: Problem building Octave

[Nir Krakauer]

> Can you try "make -j1 V=1" (no need to run make clean), and post the error 
> message?

I get the error below.
Is there a way to just build Octave without generating all the documentation?

-- Nir


...
(~/octave/.build/doc/interpreter/bugs.texi Appendix D [1016] [1017]
[1018] [1019] [1020]) (~/octave/.build/doc/interpreter/install.texi
Appendix E [1021] [1022] [1023] [1024] [1025] [1026] [1027] [1028] [1029]
[1030] [1031] [1032]
Overfull \hbox (13.40666pt too wide) in paragraph at lines 819--827
 []@textrm You must en-sure that all For-tran sources ex-cept those in the @tex
ttt liboctave/external/ranlib[]|
[1033] [1034] [1035]) (~/octave/.build/doc/interpreter/grammar.texi
Appendix F [1036] [1037]) (~/octave/.build/doc/interpreter/gpl.texi
Appendix G [1038] [1039] [1040] [1041] [1042] [1043] [1044] [1045] [1046]
[1047] [1048]) (~/octave/.build/doc/interpreter/cp-idx.texi
(Concept Index) [1049] [1050]
No file octave.cps.
) (~/octave/.build/doc/interpreter/fn-idx.texi (Function Index)
[1051] [1052]
No file octave.fns.
) (~/octave/.build/doc/interpreter/op-idx.texi (Operator Index)
[1053] [1054]
No file octave.ops.
) (~/octave/.build/doc/interpreter/pr-idx.texi
(Graphics Properties Index) [1055] [1056]
No file octave.prs.
) [1057] [1058] )
Output written on octave.dvi (1074 pages, 3263768 bytes).
Transcript written on octave.log.
/usr/bin/texi2dvi: etex exited with bad status, quitting.
make[2]: *** [Makefile:31084: doc/interpreter/octave.dvi] Error 1
make[2]: Leaving directory '~/octave/.build'
make[1]: *** [Makefile:27418: all-recursive] Error 1
make[1]: Leaving directory '~/octave/.build'
make: *** [Makefile:11051: all] Error 2