I am very thankful to many good guidnances from Nicholas and others for the
problem of symbolic.
By the way, the next problem is to run this program RBCkato.m
Well, I ran this program by matlab and then matlab prosecute it
succcessfully and gave a result.
However, when I use Octave and ran this; then there happpens many errors;
so many errors massages could not be copied all here.
some of thems:
1) >> syms ct kt lt rt vt ca ka la ra va ;
warning: the 'syms' function belongs to the symbolic package from Octave
which you have installed but not loaded. To load the package, run 'pkg
load symbolic' from the Octave prompt.
What part of the above message do you not understand?
**my comments: actually, my symbplic is working good and no problem.
2) error: 'va' undefined near line 2 column 14
>> wt = (1-alpha)*vt*(kt/lt)^alpha;
error: 'vt' undefined near line 1 column 23
>> % Optimal Conditions & state transition
>> labor = lt^lamda-wt/(myu*ct^sigma) ; % LS = LD
error: Invalid call to lt. Correct usage is: -- lt (X, Y)
3) >> [W, V] = eig(A);
error: 'A' undefined near line 3 column 15
>> Q = inv(W);
error: 'W' undefined near line 1 column 12
>> theta = diag(V); error: 'V' undefined near line 2 column 17
4) error: operator *: nonconformant arguments (op1 is 0x0, op2 is 2x1)
>> SY = [S1' ;S] ;
error: vertical dimensions mismatch (1x2 vs 24x0)
>> X = (real(P)*SY')';
error: 'SY' undefined near line 1 column 20
All these similar kinds of errors were happened.
But when i use matlab, there are no such problems and showed the results!
Could you guide me to solve this problem at Octave?
Thank you very much!
Sent from: http://octave.1599824.n4.nabble.com/Octave-General-f1599825.html