On Mon, Feb 10, 2014 at 7:28 PM, MrWilly <address@hidden> wrote:
It was a matter of installing the 32-bit version of OpenDSS. Only the 64-bit
version was available to communicate with Matlab.
info on the use of the Octave cmd prompt or other GUI options would be much
appreciated. Is it simply a matter of me learning linux or dos commands? The
lack of an ability to copy & paste into the cmd prompt is killing my
efficiency.
try 3.8.0 it will copy and paste.
You should be using a file.
Open a file in a text editor (gedit) and put your commands in a file, then save the file with a .m extension.
Then from the command prompt type the file name and enter and it will run the commands that are in the file.