Re: how to change scale display in imagesc

[febty febriani]

thanks for your response. but it did not work for my case. I used this command to reverse y-axis : set(gca,"ydir","normal").

your sincerely,
febty

2009/9/8 Christophe Tournery <address@hidden>

You may want to try:
axis xy
-c

On Sep 7, 2009, at 6:25 AM, febty febriani wrote:

Dear all,

I plotted the attached figure with using imagesc. My question is how to change the scale display so that the y- scale from 0 to 0.5, not from 0.5 to 0 like the attached figure. Any thoughts are appreciated. Thanks very much..


Your sincerely,
Febty
--

******
febty febriani
Indonesian Institute of Sciences
Research Center for Physics
Kompleks PUSPIPTEK
Serpong, Indonesia, 15314

<output20090101.png>_______________________________________________
Help-octave mailing list
address@hidden
https://www-old.cae.wisc.edu/mailman/listinfo/help-octave

-- 

******
febty febriani
Indonesian Institute of Sciences
Research Center for Physics
Kompleks PUSPIPTEK
Serpong, Indonesia, 15314