Re: Octave from CDROM

[Lukas Richterek]

Dear Michael,

thank You very, very much, it really works!!! 

Please, allow me to ask another question connected with the graphics in
octave 2.9.13. So far, I has been using only stable versions 2.1.xx...

If I try "demo" commands such as "peaks(30)" as well as simple mesh or surf
plots, I got only gray plots, but even worse, there is no mesh in fact,
only surface curves in x-direction are plotted, not in the y-direction (I
mean on the monitor, "print -deps" gives the mesh in the eps file). Is it a
problem with gnuplot terminal? How could I change it please? And more --
the hidden3d mode seams to be switched off (also not in eps file).

I know about some matlab commands like "grid on". But are there any
equivalents to

__gnuplot_set__ pm3d at s
__gnuplot_set__ hidden3d
__gnuplot_set__ tics out
__gnuplot_set__ nokey
__gnuplot_set__ nocolorbox
__gnuplot_set__ view map
__gnuplot_set__ decimal_sign ","
__gnuplot_set__ pallete rgbformulae 33,13,10
__gnuplot_raw__ "reset;"
etc.

If I try them, there is no warning, but also no effect, either with
"replot" nor with "gnuplot_command_replot".

As most of my scripts use those "obsolete" commands, at this time I would
prefer to switch on an "old compatibility mode", if possible. But
generally and perspectively, I appreciate any explanation and hint.

Thank You for Your patience and kindness!
Sincerely,
Lukas R.

> I didn't think about the case of console (I don't use it). Indeed, the
> configuration
> file used by console.exe is not relocatable. What you can try instead is
> 
> cd Octave\bin
> octave.exe
> 
> Michael.

-- 
Department of Experimental Physics 
Fac. Nat. Sciences, Palacky University
17. listopadu 50, Olomouc, 772 00 
C z e c h   R e p u b l i c
tel.: +420-585 634 103
fax:  +420-585 225 737                
mobile: +420-728 215 341
e-mail: address@hidden       /|||\
http://optics.upol.cz/~richterek/  ( o|o )
----------------------------------- \ u /