help-octave
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: saving plots


From: Matthias Brennwald
Subject: Re: saving plots
Date: Mon, 19 Jun 2006 14:10:04 +0200

Jim, thanks for this. Lets assume I want to implement some 'clone' function of the print command that allows working with multiplot using __gnuplot_***__ commands. Then, before a '__gnuplot_set__ term ps' command, the function should find out the current terminal, so that after 'replotting' the plot to a file, the terminal type can be reset to what it was before. I played with __gnuplot_show__ , but couldn't make it work. Any ideas on how to get the current terminal type?

Matthias

On 19.06.2006, at 10:03, address@hidden wrote:


On 6/18/06, Hayden Rampadarath <address@hidden> wrote:
how do you save plots using octave??

Use the 'print' command. Type 'help print' at the Octave prompt.

Unfortunately, in some circumstances the print command fails; in particular
when the multiplot features of gnuplot are in use.

In this case (and in all cases actually), your approach is still sound, it just
needs a little modification.

Replace "set" with "__gnuplot_set__", and you should be good to go. It used to be "gset", and you can still use that, but it is deprecated and may disappear in future versions of octave. "__gnuplot_set__" should be around until octave has an integrated whiz-bang graphics system, and no longer requires sending
gnuplot commands directly from the octave command line.

Jim Phillips



-------
Matthias Brennwald
L├Ągernstrasse 6
CH 8037 Z├╝rich
+41 (0)44 364 17 03
address@hidden





reply via email to

[Prev in Thread] Current Thread [Next in Thread]