figure

[Maitland Bottoms]

Hi,

I just figured this out myself...

First, explicitly set two variables:
  gnuplot_has_frames=1;
  gnuplot_has_multiplot=1;

Then, have at it... 
  figure(0);
  multiplot (1,3);
  title('500');
  mplot(abs(sc(500,:)));
  title('501');
  mplot(abs(sc(501,:)));
  title('502');
  mplot(abs(sc(502,:)));

(I happen to have a matrix sc I wanted to view cuts through. Your data 
will likely be a little different.)

My guess is that the default definitions of gnuplot_has_frames and
gnuplot_has_multiplot are conservative, and that there is no
auto-magic to set them when you are running octave and gnuplot.

That's what ~/.octaverc is for, I guess.

-Maitland

>>>>> "Joerg" == Joerg Schreiber <address@hidden> writes:

    Joerg> Hi I am just trying to change from matlab to octave.

    Joerg> I just tried:

    Joerg> octave:15> figure (2)
    Joerg> error: figure: gnuplot doesn't appear to support this


    Joerg> What's going wrong? Can this be a problem of x11 / X11 ?

    Joerg> regards, joerg