[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Is it possible to break from a GMAKE foreach loop and then exit from
|
From: |
Pierre Rouleau |
|
Subject: |
Re: Is it possible to break from a GMAKE foreach loop and then exit from make? |
|
Date: |
Mon, 30 May 2022 15:04:09 -0400 |
On Mon, May 30, 2022 at 1:52 PM Paul Smith <psmith@gnu.org> wrote:
>
> It may not be worth worrying about until you actually start to run into
> problems. Premature optimization is the cause of a lot off issues in
> programming, and also build systems :).
>
That's for sure!
--
/Pierre
- Is it possible to break from a GMAKE foreach loop and then exit from make?, Pierre Rouleau, 2022/05/27
- Re: Is it possible to break from a GMAKE foreach loop and then exit from make?, Kaz Kylheku, 2022/05/28
- Re: Is it possible to break from a GMAKE foreach loop and then exit from make?, Pierre Rouleau, 2022/05/29
- Re: Is it possible to break from a GMAKE foreach loop and then exit from make?, Paul Smith, 2022/05/29
- Re: Is it possible to break from a GMAKE foreach loop and then exit from make?, Pierre Rouleau, 2022/05/29
- Re: Is it possible to break from a GMAKE foreach loop and then exit from make?, Paul Smith, 2022/05/30
- Re: Is it possible to break from a GMAKE foreach loop and then exit from make?, Pierre Rouleau, 2022/05/30
- Re: Is it possible to break from a GMAKE foreach loop and then exit from make?, Paul Smith, 2022/05/30
- Re: Is it possible to break from a GMAKE foreach loop and then exit from make?,
Pierre Rouleau <=