help-hurd
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: boot hangs on network device driver load


From: Paul Bukowski
Subject: Re: boot hangs on network device driver load
Date: Wed, 02 Feb 2005 18:12:22 +0000

Thanks, but i think it is imposible to run current gnumach on my laptop
with ethernet device without changing NIC irq :(

here is some entries from `lspci`:

00:1d.1 USB Controller: Intel Corp. 82801CA/CAM USB (Hub #2) (rev 02) (prog-if 00 [UHCI])
       Subsystem: Asustek Computer, Inc.: Unknown device 1402
       Flags: bus master, medium devsel, latency 0, IRQ 9
       I/O ports at d400 [size=32]

00:1f.1 IDE interface: Intel Corp. 82801CAM IDE U100 (rev 02) (prog-if 8a [Master SecP PriP])
       Subsystem: Asustek Computer, Inc.: Unknown device 1402
       Flags: bus master, medium devsel, latency 0, IRQ 9
       I/O ports at <ignored>
       I/O ports at <ignored>
       I/O ports at <ignored>
       I/O ports at <ignored>
       I/O ports at a400 [size=16]
       Memory at e3000000 (32-bit, non-prefetchable) [size=1K]

01:03.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
       Subsystem: Asustek Computer, Inc.: Unknown device 1045
       Flags: bus master, medium devsel, latency 84, IRQ 9
       I/O ports at c800 [size=256]
       Memory at e6800000 (32-bit, non-prefetchable) [size=256]
       Capabilities: [50] Power Management version 2


I found in oskit source comment that it works with shared irq... is this implementation broken? unfortunatly i cannot compile it... some errors... i'm working on it;)

Paul Bukowski





reply via email to

[Prev in Thread] Current Thread [Next in Thread]