Re: grub fails to boot, prints only a single dot

[Andrei Borzenkov]

On Tue, Jun 9, 2015 at 5:44 PM, Alex Regan <address@hidden> wrote:
> Hi,
>
>>> http://pastebin.com/Q1A815Y7
>>>
>>
>> Looks good (for each of four disks).
>>

Except that it did not show grub.cfg, but that is script problem;
something to look at.

>> => Grub2 (v2.00) is installed in the MBR of /dev/sda and looks at sector 1
>> of
>>      the same hard drive for core.img. core.img is at this location and
>> looks
>>      for (mduuid/ad9fa861cc3b7cc3409746ed14c25431)/grub2.
>>
>> Could you run grub2-install using additional parameters
>>
>> --debug --debug-image=all
>>
>> and send me output of grub2-install? debug-image will enable debugging
>> for loaded grub image so you hopefully will get a lot of output; it
>> may give some hint where it stops.
>
>
> Okay, I'm attaching it here.
>

Well, it still looks good but you have a bit dated grub2 (still with
shell scripts). Did you try to boot it?