[Help-glpk] Table Statement with Single ValueParameters

[Michael Bleau]

Hi,

 

I am fairly new to GLPK so excuse me if this is too obvious.  I am trying to load data into dimensionless (single value) Parameters using a table statement.  I cannot seem to get the syntax right.  For example with:

 

table data IN "CSV" "./WDOInputData/WDO2InputParms.txt" :

      SHIP_PENALTY ~ ShipPenalty,

      SHIP_LTL_PENALTY ~ ShipLTLPenalty,

      SHIP_SMALL_PENALTY ~ ShipSmallPenalty,

      NON_GD_PENALTY ~ NonGDPenalty,

      DC_OFF_MID_PENALTY ~ DCOffMidPenalty,

      DC_CUBE_OVER_HIGH_PENALTY ~ DCCubeOverHighPenalty,

      DC_CUBE_UNDER_LOW_PENALTY ~ DCCubeUnderLowPenalty,

      DC_CUBE_OVER_PEAK_PENALTY ~ DCCubeOverpeakPenalty;

 

I get the following message:

 

Reading model section from WDOFormulation.mod...

WDOFormulation.mod:104: SHIP_PENALTY not a set

Context: ...IN_REGION_PENALTY ; table data IN '...' '...' : SHIP_PENALTY

 

Thanks for any ideas ...

 

Mike

 

 

(GLPK 4.29, Microsoft Vista, Compiled with VisualStudio C++)

--
_________________________________
Michael Bleau
Michael Bleau & Associés
Tel:  514 247-2944 
address@hidden