|
From: | Humberto Freitas |
Subject: | [Health] Problems with installation |
Date: | Wed, 24 Jul 2019 14:26:22 +0100 |
Hello Axel, thanks for your response.Dont know which repos you are using, but trytond 4.6 is for python 3The repos I’m using are the official ones located at https://downloads.tryton.org/4.6/ Sounds like you did a vanilla installation, and during this the use of python I was installing GH in a virtual environment with pyenv, and apparently it didn’t go so well. After investigating the messages coming from executing $ ./gnuhealth-setup install, I could notice several messages saying pyenv: 2to3: command not found The `2to3' command exists in these Python versions: 3.7.3 So I think that the issue is with pyenv. Because the setup cannot find the command 2to3, so it cannot convert Tryton 4.6 from python2 to python3. I could install GH without pyenv though. However, for testing and demonstration cases I would like to be able to install GH with pyenv. Any ideas guys? |
[Prev in Thread] | Current Thread | [Next in Thread] |