Re: grub2 (1.97.1) on RAID0

[André Fettouhi]

That sucks big time! <Sad>

address@hidden skrev:
> To bad :)
> Its not possible to use dmraid with Grub2 yet.
>
> I had to switch bad to grub1 because its not possible to get it working.
> Hopefully some developper wants to implement this :)
>
> Sincerely,
> Jean-Louis
>
> On Thu, 12 Nov 2009 11:19:50 +0100, "André Fettouhi"
> <address@hidden>
> wrote:
>   
>> I'm using Arch Linux 64bit and I want to switch to grub2 since 2.0 is
>> getting somewhat close. I'm running a RAID0 (using dmraid) setup and I
>> can't figure out how to install grub2 on RAID0. With the legacy grub I
>> have to go into the grub command prompt and do the following
>>
>> # dmsetup mknodes
>> # grub --device-map=/dev/null
>> grub> device (hd0) /dev/mapper/raid_set
>> grub> geometry (hd0) C H S
>>
>> grub> root (hd0,0)
>> grub> setup (hd0)
>> grub> quit
>> # reboot
>>
>> how can I do this in grub2?
>>     
>
>
> _______________________________________________
> Grub-devel mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/grub-devel
>   

-- 
---------------------------------------------------------------
Dr. rer. nat. André Fettouhi, Postdoc.
Center for Phase Equilibria and Separation Processes (IVC-SEP)
DTU Chemical Engineering
Department of Chemical and Biochemical Engineering
Technical University of Denmark
Søltofts Plads
Building 229, room 218
2800 Kgs. Lyngby
Denmark
Telephone: +45-45252978
Fax: +45-45882258
E-Mail: address@hidden
---------------------------------------------------------------