Re: installing on x86_64

[Jerone Young]

Are you sure you did this on an x86-64 install. Current CVS still
suffers from the not being able to properly compile on x86-64 systems.
I am looking into it again now, but I think you may be mistaken in how
you are using it? What distro & gcc version are you using ?

On 5/22/07, Constantine Kousoulos <address@hidden> wrote:
> Hello,
>
> I fetched the latest sources from cvs and tried to install grub2.
> I followed the guide at the wiki http://grub.enbug.org/TestingOnX86.
>
> 'configure --prefix=/boot/grub2': works ok.
> 'make': ok
> 'sudo make install': complaints about missing file
> utils/grub.d/README.  easy to overcome.
> 'sudo grub-install --grub-setup=/boot/grub/grub.cfg /dev/hda':
> there is no arg like '--grub-setup'. i used instead 'grub-install
> --root-directory=/boot/grub2/ /dev/hda'
> 'sudo grub-setup  --directory=/boot/grub
> --device-map=/boot/grub/device.map /dev/hda':
> i get this error
> 'grub-setup: error: cannot stat /boot/grub2/boot.img'
> so i copy boot.img to /boot/grub2. Then i get the same complaint
> about core.img which does not exist.
>
> Any advice is welcome.
>
> Thanks,
> Constantine
>
>
> _______________________________________________
> Grub-devel mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/grub-devel