[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Satellites show up multiple times
From: |
Andreas B |
Subject: |
Re: Satellites show up multiple times |
Date: |
Wed, 5 Aug 2020 09:29:23 +0200 |
Greg,
Thank you!
Andreas
On Tue, Aug 4, 2020 at 5:53 PM Greg Troxel <gdt@lexort.com> wrote:
>
>
> Andreas B <panden@gmail.com> writes:
>
> > I'm using a ublox ZED-F9P with default settings, which works great.
> >
> > Some satellites have two entries in the seen/used list in cgps. In
> > this case, a number is appended to the constellation abbreviation for
> > the second entry (see e.g. below). In xgps, no number is appended.
> > When the satellite shows up two (or more?) times in the list, does
> > this refer to the receiver using several frequencies from the
> > satellite (L1, L2,L5)?
>
> Probably. And probably the entire scheme of passing this from receiving
> to display could use a good going over and some thought. Dual-frequency
> receivers have only recently become affordable at the hobbyist level.
>
> > The SNR difference between the two entries of PRN 7 is 11, which
> > really seems to be alot. Why this big difference?
>
> could be differences in
> tx antenna
> tx power
> propagation
> rx antenna
> rx local noise
> rx preamp noise figure
> rx preamp gain
> rx cable loss
> rx noise figure
>
> and surely other things I am not thinking of. So I do not have an
> expectation that C/N0 will match, and I don't have an expectation that
> it will not. Best to chase the signal path to make sure it all makes
> sense, first.
>
> Arguably a "where are the satelllites" list should not have multiple
> entries but a "how am I receiving it" list should. I find "3" strange,
> vs something like L1/L2. Keep in mind that Galileo has E5a and E5b. So
> there really needs to be a "signal" field added.
>
> I think I am just talking about improvements that nobody has gotten
> around to, so far.
>