[gNewSense-users] busybox

[Richard]

Hi,

i am trying to install gnewsense 2.3 but i get the busybox.

If i type 
dmesg | tail

if get the information (by writing the console to paper):

[8.801] ata1: PATA max UDMA/10 cmd oxdco ctl 0xd80 bmda 0xd40 irg 1
[8.802] ata2: PATA max UDMA/10 cmd 0xd80 ctl 0xd40 bmdma 0xd48 irq 1
[8.913] usbcore: registered new interface driver hiddev
[8.915] usbcore: registered new interface driver usbhid
[8.915]
Infs/.sda3/gnewsense-builder-temp-dir/linux-2.6.2/drivers/hid/usbhid/hid-car.c: 
v2.6:USB HID coredriver
[8.451] usb 1-2: new low speed USB device using uhci_hcd and adress3
[8.591] usb 1-2: configuration #1 chosen from 1 choice
[8.667] input: PIXART USB OPTICAL MOUSE as
idevices/pci00:0/00:=:1a.0/usb/1-2:1.0/input/input2
[8.638] input, hidrawo: USB HID v1.1 Mouse [PIXART USB OPTICAL MOUSE] on
usb-00:0.1a.0-2
[8.948] ieee19: Host added: ID:BUS[o-o:12] GUID[0106457ca0]

If i unpluque the mouse i get:

[3.480] ACPI: PCI interrupt for device 00:0:.0[A] -> GSI (level, low)
-> IRQ 1 
[3.484] PCI: Setting latency timmer of device 00:0:0.0 to 6
[3.485] ACPI: PCI interrupt for device 00:0:0.0 disabled
[3.470] ACPI: PCI interrupt for device 00:0:.0[A] -> GSI (level, low)
-> IRQ 1
[3.472] PCI: Setting latency timmer of device 00:0:0.0 to 6
[3.479] scsio: pata_jmicron
[3.473] scsi1 : patajmicron
[3.480] ata1: PATA max UDMA/10 cmd 0xdc0 ctl 0xd80 bmdma 0xd40 irq 1
[3.480] ata2: PATA max UDMA/10 cmd 0xd80 ctl 0xd40 bmdma 0xd48 irq 1
[3.897] ieee19: Host added: ID:BUS[0-0:12] GUID[0106457ca0]


I can't understand these lines.
Can someone give my some comments?
Ist it possible to install gnewsense with the busybox?

Thanks
Richard