[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[gNewSense-users] eepro100 does not 'attach' to eth0
From: |
Keith Meyer |
Subject: |
[gNewSense-users] eepro100 does not 'attach' to eth0 |
Date: |
Mon, 12 Feb 2007 11:51:21 -0500 |
Hey Everyone,
I've tried various "hacks" and "work arounds" for this problem. I have a Dell Inspiron 2200 and I just installed gNewSense 1.1. When it boots it won't load the eepro100 module that is needed for the Intel built-in ethernet. No biggie so I just run `modprobe eepro100` however running `ifconfig` will show only the loopback. After that I tried running `ifconfig eth0 up` still no dice, it gives an error that is along the lines of it's not a real device.
Any ideas where to go from here?
Keith
- [gNewSense-users] eepro100 does not 'attach' to eth0,
Keith Meyer <=