[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC)

From: Camm Maguire
Subject: Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC)
Date: 07 Nov 2003 16:05:37 -0500
User-agent: Gnus/5.09 (Gnus v5.9.0) Emacs/21.2

Greetings, and tnanks!  Gave it a quick lookover, and its nothing
obvious, though I suspect its trivial, as your compiler seems to be
working, but the exit command (bye) is triggering the error.  Don't
recognize the gcc version either.  How about a gcc -v?  In any case,
the next step is to recompile with the configure flag --enable-debug,
and if the error persists, go into the lsp subdir, gdb
../unixport/saved_pre_gcl, r, and then at the lisp prompt
(compile-file "gcl_arraylib.lsp"), then report the results of a
backtrace where gdb reports the fault (i.e. bt).

If you feel uncomfortable with any of this and can provide remote
access, I'll try to take a look.

Take care,

John Tang Boyland <address@hidden> writes:

> (I changed the subject line to be more accurate.)
> I didn't have the configure and build output captured, so I'm doing it
> again.  I couldn't find a "distclean" option ("make distclean" gave
> an unknown target error), so I just did a "clean".
> The (new) configure and build output are captured in
>     http://www.cs.uwm.edu/~boyland/temp/gcl-2.6.1-18-build.txt
> It is a full terminal capture including my messing around in
> the gmp3 directory doing the recommended reconfigure with a --build
> option.  (I'm not sure this was necessary.)
> I let it run to completion this time (24K lines). The error I
> mentioned happens on line 3558.
> John

Camm Maguire                                            address@hidden
"The earth is but one country, and mankind its citizens."  --  Baha'u'llah

reply via email to

[Prev in Thread] Current Thread [Next in Thread]