|
From: | larsen007 |
Subject: | Re: [Freeipmi-users] FreeIPMI recognizes OEM sensor, but it does not return a reasonable state for it |
Date: | Sat, 19 Feb 2011 20:26:43 +0100 |
>> # /usr/local/sbin/ipmimonitoring >> ID | Name | Type | State | Reading | >> Units | Event >> 74 | SD vFlash Status | Module/Board | N/A | N/A | >> N/A | 'OEM Event = 0000h' >> >> >> Though, the state is still shown as "N/A". > Since this is an OEM sensor, you need to specify --interpret-oem-data > (you can config it in /etc/freeipmi/freeipmi.conf so its on by default > in the future). doesn´t look very different... Did I forget something else? incubus:~# /usr/local/sbin/ipmimonitoring --interpret-oem-data --output-sensor-state ID | Name | Type | State | Reading | Units | Event 74 | SD vFlash Status | Module/Board | N/A | N/A | N/A | 'OK' Lars
[Prev in Thread] | Current Thread | [Next in Thread] |