[Freeipmi-devel] Re: symbols missing problem

[Albert Chu]

Hey Rene,

Yup, I was able to verify that rebuilding the rpm under Suse fixed the
problem.  I'm not really sure what the problem was with the old Redhat
RPMS.  Just did the typical:

> rpmbuild --rebuild freeipmi-0.2.0-1.src.rpm

If you have a number of architectures of Suse, it'd be great if you
could rebuild the rpms and we could stick em all on the website.

Al

--
Albert Chu
address@hidden
925-422-5311
Computer Scientist
High Performance Systems Division
Lawrence Livermore National Laboratory


----- Original Message -----
From: Rene Salmon <address@hidden>
Date: Friday, March 24, 2006 3:05 pm
Subject: Re: symbols missing problem

> Hi,
> 
> Just finished installing libtool, autoconf, and automake.
> So I take it I would have been better off installing from source 
> rather 
> that using the RPMs.  I take it they are RedHat based and since I 
> am 
> running SuSE it didn't quite work :-)
> 
> thanks again
> Rene
> 
> 
> Anand Babu wrote:
> > ,----[ Albert Chu <address@hidden> ]
> > | Are you running autogen.sh on the IBM? With some other 
> projects, I a
> > | recall Suse problems with autoconf/automake.  I fixed the 
> problem by
> > | running ./autogen.sh on a Redhat/Fedora/Debian system.
> > `----
> > Al, I think you are right. This is caused because of
> > not-running-autogen.sh. When I run the binary's in place from the
> > source tree (they are actually libtool scripts) they work OK. Only
> > on install they screw up. This must be caused because of configure
> > script produced from a different platform.
> > 
> > Rene, Can you please install libtool, autoconf and automake on your
> > system, So that I can run autogen.sh?
> > 
> 
> -- 
> -
> --
>         Rene Salmon
>         Tulane University
>         Center for Computational Science
>         Richardson Building 310
>         New Orleans, LA 70118
>         http://www.ccs.tulane.edu
>         Tel 504-862-8393
>         Fax 504-862-8392
> 
>