Re: [O] Org-babel & R exporting multiple tables

[Eric Schulte]

Joe Bogner <address@hidden> writes:

> Figured it out. Option #2 works with ob-org as long as the defaults
> are set to output the results
>
> (setq org-babel-default-header-args:org '((:results . "raw") (:exports
> . "results")))
>
> By default it looks like it's silent.
>

Another option may be to try option 3, but replace

  :results output raw

with

  :results output drawer

Best,

>
>
>
> On Wed, May 22, 2013 at 5:26 PM, Joe Bogner <address@hidden> wrote:
>> I have a list of data frames that I would like to output. The number
>> of frames may vary
>>
>> Is there a way to export multiple tables formatted? These are the
>> three options I came up with. None of them work very well:
>>
>> Option #3 works the best, but it will append each time it's run in the
>> doc, so I can't have the contents in the doc without having it
>> duplicated.
>>
>> Option #2 would be good if I could just instruct it to render the table as 
>> HTML
>>
>> There was a post about 2 years ago that I attempted implement by
>> adding (require 'ob-org) to my .emacs for #2 but it didn't seem to
>> work 
>> (http://article.gmane.org/gmane.emacs.orgmode/29286/match=results+org+babel+ascii).
>>
>>
>>
>> * Option 1
>>
>> Will combine the frames
>>
>> #+begin_src R :session *R* :colnames yes
>> frames <- list()
>> frames[[1]] <- data.frame(col=c("a","b"))
>> frames[[2]] <- data.frame(col2=c("a","b"))
>> frames
>> #+end_src
>>
>> #+RESULTS:
>> | col | col2 |
>> |-----+------|
>> | a   | a    |
>> | b   | b    |
>>
>>
>>
>> * Option 2
>>
>> It won't format on export
>>
>> #+begin_src R :session *R* :results output org :exports both
>> frames <- list()
>> frames[[1]] <- data.frame(col=c("a","b"))
>> frames[[2]] <- data.frame(col2=c("a","b"))
>> for(i in 1:2) {
>>     print(ascii(frames[[i]]), type="org")
>> cat("\n")
>> }
>> #+end_src
>>
>> #+RESULTS:
>> #+BEGIN_SRC org
>>  |   | col |
>>  |---+-----|
>>  | 1 | a   |
>>  | 2 | b   |
>>
>> |   | col2 |
>> |---+------|
>> | 1 | a    |
>> | 2 | b    |
>> #+END_SRC
>>
>>
>> * Option 3
>>
>> It will format on export but won't replace if it's run in the document
>>
>> #+begin_src R :session *R* :results output raw :exports both
>> frames <- list()
>> frames[[1]] <- data.frame(col=c("a","b"))
>> frames[[2]] <- data.frame(col2=c("a","b"))
>> for(i in 1:2) {
>>     print(ascii(frames[[i]]), type="org")
>> cat("\n")
>> }
>> #+end_src
>

-- 
Eric Schulte
http://cs.unm.edu/~eschulte