Re: [Orgmode] html export

[Thomas S . Dye]

Hi Eric,

On Jun 20, 2010, at 8:14 AM, Eric Schulte wrote:

"Thomas S. Dye" <address@hidden> writes:

[...]

Removing the blank line doesn't work for me either.

Org-mode version 6.36trans (release_6.36.291.gaf90f)

Hmm, I just tried the above again using the HEAD (same org-version
output as you have above) of the org-mode git repository and a minimal
emacs config, and it *is* working for me, so maybe your problems will be
resolved with an update of org-mode, or maybe they're due to something
in your config?

Ah, I'm finally able to reproduce the problem in my larger file.  Here

is an example:

* No results exported

#+srcname: problem

#+begin_src R

 b <- 4

#+end_src

#+results: problem

[[file:~/Public/projects/903_adzes/r/sr-nb-scatter.png]]

The key is that srcname: and results: have the same name.  Changing

the results: name works.

* Results exported

#+srcname: problem

#+begin_src R

 b <- 4

#+end_src

#+results: problem-not

[[file:~/Public/projects/903_adzes/r/sr-nb-scatter.png]]

Yes, the key with the above is that babel by default only exports the
code of a code block, which means that if there are results in the
buffer they will be removed on export.  If you want both the code and
the results to be exported then change

 #+srcname: problem
 #+begin_src R
   b <- 4
 #+end_src

to

 #+srcname: problem
 #+begin_src R :exports both
   b <- 4
 #+end_src

Hope this helps -- Eric

I didn't pay close attention when the default behavior changed.  Adding #+property: exports both gets me back where I was before.  

Also, following on Nick's message, the captions exported properly to html with absolute paths in the links and with lots of space between the caption and link.  Here's an example that exported properly:

#+CAPTION: Pairwise comparison of six metric variables

#+LABEL: fig:pairwise

#+srcname: pairs

#+begin_src R :results output :var x=whole-adzes :file r/adze_pairs.png

  whole.adze.metric <- x[,c(5,12,15,16,17,18)]

  names(whole.adze.metric) <- c("wt","len","edge","front","back","thick")

  pairs(whole.adze.metric)

#+end_src

#+results: pairs

[[file:r/adze_pairs.png]]

Thanks for your help.

Tom