[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Should lisp/Makefile.in custom-deps be using EMACS or emacs?
From: |
Rob Browning |
Subject: |
Re: Should lisp/Makefile.in custom-deps be using EMACS or emacs? |
Date: |
Thu, 25 Jul 2002 14:45:41 -0500 |
User-agent: |
Gnus/5.090006 (Oort Gnus v0.06) Emacs/21.2 (i386-pc-linux-gnu) |
Richard Stallman <address@hidden> writes:
> In the case that fails, can you try running by hand under GDB the
> command that actually uses cus-dep.el and step through the code in
> init_lread which sets up load-path, to see why the installed Lisp
> directories end up in the value? That's the only way to
> figure this out. Treating it as a black box won't get anywhere.
OK, but I didn't realize ./src/emacs was doing anything wrong. In
lisp/Makefile, EMACS is set to ./src/emacs and EMACS is what's used to
run custom-deps. Isn't ./src/emacs the binary that's eventually
installed in bindir? If so, then isn't it *supposed* to be using the
installed Lisp directories (unless it's overridden by EMACSLOADPATH or
similar)?
If that's right, then I running gdb on emacs probably won't help, but
using $(emacs) instead of $(EMACS) would (or something similar). If
that's wrong, then part of the problem is that I'm misunderstanding
the semantics here.
--
Rob Browning
rlb @defaultvalue.org, @linuxdevel.com, and @debian.org
Previously @cs.utexas.edu
GPG=1C58 8B2C FB5E 3F64 EA5C 64AE 78FE E5FE F0CB A0AD
- Should lisp/Makefile.in custom-deps be using EMACS or emacs?, Rob Browning, 2002/07/08
- Re: Should lisp/Makefile.in custom-deps be using EMACS or emacs?, Eli Zaretskii, 2002/07/08
- Re: Should lisp/Makefile.in custom-deps be using EMACS or emacs?, Richard Stallman, 2002/07/09
- Re: Should lisp/Makefile.in custom-deps be using EMACS or emacs?, Rob Browning, 2002/07/27
- Re: Should lisp/Makefile.in custom-deps be using EMACS or emacs?, Richard Stallman, 2002/07/28
- Re: Should lisp/Makefile.in custom-deps be using EMACS or emacs?, Rob Browning, 2002/07/30