Receiving data from Rxs, processing and sending the results through TX

From:

Simona Sibio

Subject:

Date:

Thu, 14 Nov 2019 19:07:27 +0000

Dear all,

I am writing to you because I would like to implement the following project on Gnuradio:

- Two Rxs receive the data and the processing is real time.

- The outcomes (amplitude and phase) should go in a signal generator to transmit on Tx.

I implemented something but it is not so efficient (see attached flowgraph). I would like to disconnect the receivers with the transmitters so I can attenuate the noise and obtain a better signal on the TX.

Is there some block where I can storage my parameters and send into signal generator variable?

I would like to find something like the GT GUI Entry but, instead, to insert the value from the pannel, I want that my output form the algorithm changes the value into the generator.

I am using two N200, an octoclock.

Thank you for your time.

Best Regards,

Simona

[Prev in Thread]

Current Thread

[Next in Thread]

Receiving data from Rxs, processing and sending the results through TX, Simona Sibio <=