[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Getting the gdb commands to work in the .gdbinit file
From: |
Conover, John |
Subject: |
Getting the gdb commands to work in the .gdbinit file |
Date: |
Thu, 5 Jul 2001 15:09:20 -0400 |
Hi,
I've been running ddd 3.3 with some success, but have the annoying
problem of
not being able to run the following commands in a batch file. If I enter the
commands in the at the command prompt everything is fine. But trying to put
them
into either .gdbinit or a command button will not work.
set gnutarget coff-go32
set confirm on
cd /home
dir /home/build/gatorMgr
set remotebaud 57600
add-symbol-file /home/build/atmBase/ATM 0x7c0020
target remote /dev/ttyS0
When I run the commands in the .gdbinit file I get:
.gdbinit:3: Error in sourced command file:
"on" or "off" expected.
There must be a simple way of doing this, but I can not find
documentation
for either ddd or gdb to do this.
Any help would be appreciated.
John Conover
address@hidden
- Getting the gdb commands to work in the .gdbinit file,
Conover, John <=