bug#70698: python-pivy build fails (freecad dependency)

[Buttons Presser]

Dear guix community,

My local python-pivy build fails and there is no longer a working substitute 
available.

The build log is attached 
(q806khpbab7n9nk9i6ynbfhm85gd48-python-pivy-0.6.5.drv.gz).

I suspect that python-pivy stoped building after recent patches to coin3d - 
https://issues.guix.gnu.org/70305

Looks like this is an issue with paths in the python-pivy install scripts 
(build phase: python setup.py). Specifically in its swig command which probably 
misses some paths to soqt and coin3D.

I was trying to fix and upgrade the python-pivy before because the current 
version  is 0.6.5 is old and some features of freecad was not working properly 
- https://issues.guix.gnu.org/70258. I guess there should be a patch to the 
python-pivy cmake config that can fix the paths to soqt and coin3D but I am not 
familiar with cmake and thus far did not find a solution.

Kind regards,
BP

q806khpbab7n9nk9i6ynbfhm85gd48-python-pivy-0.6.5.drv.gz
Description: Binary data