grub_tpm_measure not found

[Ken Hall]

Fedora 29 system has two SATA hard drives (sda and sdb) in MD Raid 1 configuration, both drives were set up with grub2 under previous version of Fedora.  Replaced sda (default boot drive), and re-synced MD raid successfully.  Ran grub-install on /dev/sda successfully.  System will not boot from new drive, error message "grub_tpm_measure not found", and drops into grub rescue.  I can still boot from sdb successfully, however the point of this is to replace both drives, and I cannot replace sdb until I can successfully boot from sda.  The motherboard is an MSI desktop mainboard, which as far as I know does not support TPM.  CPU is AMD FX(tm)-4300 Quad-Core Processor.

grub2-tools-extra-2.02-62.fc29.x86_64

grub2-starfield-theme-2.02-0.38.fc25.x86_64

grub2-tools-minimal-2.02-62.fc29.x86_64

grub2-tools-2.02-62.fc29.x86_64

grub2-tools-efi-2.02-62.fc29.x86_64

grub2-pc-modules-2.02-62.fc29.noarch

grub2-common-2.02-62.fc29.noarch

grub2-pc-2.02-62.fc29.x86_64

I opened a Bugzilla with Red hat for this, but so far nobody has followed up.  I can’t find any reference to “grub_tpm_measure” in any searches, it does not seem to be a module, apparently a symbol, but no references.