[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Double sync required on ext3, Linux 2.4.x
From: |
Pavel Roskin |
Subject: |
Double sync required on ext3, Linux 2.4.x |
Date: |
Fri, 8 Feb 2002 18:58:46 -0500 (EST) |
Hello!
I have had weird problems with GRUB several times, and now it seems that I
have found the solution. Maybe it's not complete, but worth applying
nevertheless.
Once I installed GRUB 0.91 over GRUB 0.90 with grub-install. The system
wouldn't boot. I booted from a floppy and bound that /boot/grub/stage2
has "0.90" in it. In other words, the old stage2 was overwritten by the
script, but the grub shell resurrected the old file!
Then I removed all files except device.map and menu.lst from /boot/grub/
and ran grub-install. It reported that it cannot find stage1. However,
the file was present when the script finished.
The following procedure reproduces the problem reliably:
=============================================
# mv /boot/grub /boot/grub.save
# cp -a /boot/grub.save /boot/grub
# rm -f /boot/grub/stage*
# grub-install '(hd0)'
GRUB version 0.91 (640K lower / 3072K upper memory)
[ Minimal BASH-like line editing is supported. For the first word, TAB
lists possible command completions. Anywhere else TAB lists the
possible
completions of a device/filename. ]
grub> root (hd0,5)
Filesystem type is ext2fs, partition type 0x83
grub> setup --stage2=/boot/grub/stage2 --prefix=/boot/grub (hd0)
Checking if "/boot/grub/stage1" exists... no
Error 15: File not found
grub> quit
=============================================
However, adding one more sync() to grub/main.c fixes the problem. Here's
the patch.
=============================================
--- ChangeLog
+++ ChangeLog
@@ -1 +1,6 @@
+2002-02-08 Pavel Roskin <address@hidden>
+
+ * grub/main.c (main): Call sync() twice - it's required on ext3
+ with Linux-2.4.18-pre9.
+
2002-02-08 Yoshinori K. Okuji <address@hidden>
--- grub/main.c
+++ grub/main.c
@@ -135,6 +135,7 @@ main (int argc, char **argv)
actually written to disks. This is very important because GRUB does
not use ordinary stdio interface but raw devices. */
sync ();
+ sync ();
program_name = argv[0];
default_boot_drive = boot_drive;
=============================================
As the ChangeLog says, I'm using the latest and greatest
Linux-2.4.18-pre9, but it's the problem most likely exists for other
kernels and maybe even filesystems.
The best solution would be perhaps adding --stage1 option for the "setup"
command and avoiding any direct access to files, even read-only access.
--
Regards,
Pavel Roskin
- Double sync required on ext3, Linux 2.4.x,
Pavel Roskin <=