After using Edit Position to set up a particular
position, the Game -> Swap Players command fails to swap the entire
board. Sometimes just the dice and turn are swapped, other times some of
the checkers are swapped but not all. I've double-checked to amke sure I
didn't leave it in Edit mode, and the problem still occurs even a few moves
after the edit took place.
This presents a problem when trying to evaluate a
checker play or cube decision. If the move in question occurs on the
computer's turn, one can only accept the computer's chosen move. To
explore what happens "from the other side of the board" one would like the
ability to swap players and go from there. I tried the work-around of
setting the top player to human and bottom player to computer, but it's a bit
unnerving playing upside-down.
Is it possible to make "Swap Players" work
following and "Edit Position"?
Ned
|