Re: [Bino-list] native 3D-TV support (request)

[Martin Lambers]

Hi Daniel!

On 16/03/11 10:51, Daniel Fratzscher wrote:
> Is it possible to add 2 additional output modes for using a 3D-TV? I
> managed to create proper modelines to switch to Televisions 3D-Modes.
> The modes are close to the top-bottom-mode but with a couple of blank
> lines between them.
> 720p-3D:     left frame:    from 0/0 to 1280/720                        
>             (upper-left and lower-right corners)
>                      right frame:  from 0/750 to 1280/1470 (30 blank
> lines between frames)
> 1080p-3D    left frame:    from 0/0 to 1920/1080
>                      right frame:  from 0/1125 to 1920/2205 (45 blank
> lines between frames)

It is certainly possible to add such modes, but I have a few questions:
Are the "720p-3D" and "1080p-3D" modes that you list above some kind of
documented output modes for some 3D TVs? Are they standardized somewhere?

I ask because we could either add two new output modes, or, if these
modes just happen to work on your TV and other TVs need a different
number of blank lines, we could add a configurable number of blank lines
for the existing top-bottom output mode.

Martin